ISO INTERNATIONAL STANDARD 14656 First edition 1999-12-15 Epoxy powder and sealing material for the coating of steel for the reinforcement of concrete Poudre époxy et materiau de reparation pour le revetement des armatures en acierpour béton Reference number ISO 14656:1999(E) ISO @ ISO 1999 by IHS under lic ted without license from IHS Not for Resale ISO 14656:1999(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the ?ISO1999 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ISO1999-All rightsreserved ermittedwithout license from IHS Not for Resale ISO 14656:1999(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO technical liaison with sO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3 Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 14656 was prepared by Technical committee ISO/TC 17, Steel, Subcommittee SC 16, Steels for the reinforcement and prestressing of concrete.