ISO INTERNATIONAL STANDARD 10571 Third edition 2016-04-01 Tyres for mobile cranes and similar specialized machines Pneumatiques pour grues mobiles et engins spéciaux similaires Reference number A IS0 10571:2016(E) ISO International Organization for Standardization =ZHEJIANG INST OF STANDARDIZATION C1 5956617 @IS02016 vided by IHS under lic itted without license from IHS IS0 10571:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. IsOcopyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org PrganizationforStandardization ensee-ZHEJIANG INST.OF STANDARDIzARoISQ16- All rights reserved etworking permitted without license from IHS IS0 10571:2016(E) Contents Page Foreword ..iv 1 Scope .1 2 Normative references ..1 3 Terms and definitions 4 Tyre designation and marking 4.1 Tyre size designation and service description .1 4.1.1 Nominal section width 4.1.2 Nominal aspect ratio 1 4.1.3 Tyre construction code .2 4.1.4 Nominal rim diameter code 4.1.5 Service description. .2 4.2 Service identification (Regional option) 2 4.3 Load range (Regional option) 2 4.4 Other service characteristics. 2 4.5 Example. .2 5 Tyre dimensions .3 6 Tyre load capacities. .3 6.1 Basic tyre loads .3 6.2 Limitations.. .3 6.3 Tyre loads at speeds other than reference speed .3 6.4 Tyre selection.. .3 7 Approved rim contours .4 Annex A (normative) Nominal section width steps. .8 Bibliography 9 iii ee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS under lic vithout license from IHS Not for Resale, 2016/7/20 02:47:29