EN IS0 27548 EUROPEANSTANDARD NORME EUROPEENNE EUROPAISCHE NORM July 2024 ICS 13.040.30; 13.100; 25.030 English Version Additive manufacturing of plastics - Environment, health and safety - Test method for determination of particle and chemical emission rates from desktop material extrusion 3D printer (IS0 27548:2024) Fabrication additive de plastiques - Environnement, Additive Fertigung von Kunststoffen - Umwelt, santé etsécuritée-Méthoded'essaipour la Gesundheit und Sicherheit -Prufverfahren zur détermination des taux d'émission de particules et de Bestimmung der Partikelemissionsrate und der produits chimiques des imprimantes 3D de bureau par chemischen Emissionsrate von extrusion de matériau (IS0 27548:2024) materialextrusionsbasierten Desktop-3D-Druckern (ISO 27548:2024) This European Standard was approved by CEN on 6 July 2024. CENmembersareboundtocomplywiththeCEN/CENELECInternalRegulationswhichstipulatetheconditionsforgivingthis European Standard thestatus ofanational standard without anyalteration.Up-to-datelists and bibliographical references concerningsuchnationalstandardsmaybeobtainedonapplicationtotheCEN-CENELECManagementCentreortoanyCEN member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CEN member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions. CEN members are the national standards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway Poland,Portugal, Republic of North Macedonia,Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland,Turkiye and United Kingdom. ce EUROPEAN COMMITTEEFOR STANDARDIZATION COMITEEUROPEENDENORMALISATION EUROPAISCHES KOMITEE FUR NORMUNG CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels 2024CEN All rights of exploitation in any form and by any means reserved Ref. No. EN IS0 27548:2024 E worldwidefor CEN national Members. EN IS0 27548:2024 (E) Contents Page European foreword.. 2 EN IS0 27548:2024 (E) European foreword This document (EN IS0 27548:2024) has been prepared by Technical Committee IS0/TC 261 "Additive manufacturing" in collaboration with Technical Committee CEN/TC 438 "Additive Manufacturing" the secretariat of which is held by AFNOR. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by January 2025, and conflicting national standards shall be withdrawn at the latest by January 2025. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN shall not be held responsible for identifying any or all such patent rights. Any feedback and questions on this document should be directed to the users' national standards body/national committee. A complete listing of these bodies can be found on the CEN website. According to the CEN-CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Tirkiye and the United Kingdom. Endorsement notice The text of IS0 27548:2024 has been approved by CEN as EN IS0 27548:2024 without any modification. 3